Before using this vehicle, the operator should always:  

• Apply parking brake and check if it operates properly.
• Check tire pressure and condition.
• Check wheels and bearings for wear and damage.
• Check location of controls and ensure they work properly.
• Verify if steering operates freely. Activate throttle control lever several times to ensure it operates freely. It must return to idle position when released.
• Activate the brake levers and brake pedal to make sure the brakes fully apply. Levers and pedal must fully return when released.
• Ensure transmission lever is working then reset in NEUTRAL position.
• Check drive chain for adjustment and lubrication.
• Check sprockets for wear and damages.
• Check fuel, oil and coolant levels. Check for oil leaks on the engine/transmission and drive train components.
• Ensure fuel valve is in fully open position (ON).
• Clean headlamps and taillight.
• Ensure front access compartment cover is properly latched.
• Ensure seat is properly latched.
• If you transport cargo, respect load capacity.
• If you are pulling a trailer or other equipment, ensure it respects the tongue capacity and towing capacity. Ensure trailer is properly secured to hitch.
• Look and feel for loose parts while engine is off. Check fasteners.
• Ensure the path of travel is free of persons and obstacles.
• Check operation of ignition switch, engine start button, engine stop switch and headlamps.
• Start engine, remove parking brake and drive forward slowly a few feet then apply all brakes individually to test them.

Correct any problem you may have found before riding. See an authorized dealer as necessary.